English | 19Auxiliary Input Display SettingSelecting the display when this device is switchedto Auxiliary input source.1 Select Auxiliary input sourcePress the [SRC] button.Select the "AUX" display.2 Enter Auxiliary input display setting modePress the [NAME.S] button for at least 2seconds.The presently selected AUX Name is blinks.3 Select the Auxiliary input displayPress the [4] or [¢] button.Each time the button is pressed it switchesthrough the below displays.• "AUX"• "TV"• "VIDEO"• "GAME"• "PORTABLE"• "DVD"4 Exit Auxiliary input display setting modePress the [NAME.S] button.• When operation stops for 10 seconds, the nameat that time is selected, and Auxiliary input displaysetting mode closes.• The Auxiliary Input Display can be set only when thebuilt-in auxiliary input or the auxiliary input of optionalKCA-S210A is used.Panel Position SettingSetting the angle or back-forward position of thecontrol panel.1 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "PNL" isdisplayed above the [4]/ [5] button.2 Enter Panel Position Setting modePress the [4] ("PNL") (KDC-W8027)/ [5] ("PNL")(KDC-PSW9527/W9027) button.3 Select the item for adjustmentPress the desired [2] — [5] button.Each time the button is pressed the items thatcan be adjusted switch as shown below.Adjustment Item Button DisplayThe panel tilts upwards. [2] "ANG–"The panel tilts downwards. [3] "ANG+"The panel slides backward. [4] "SLD–"The panel slides forward. [5] "SLD+"4 Exit Panel Position Setting modePress the [6] ("RTN") button.• The control panel may be interfered with the shiftlever or another part depending on the angles of thecontrol panel.Set the angle to avoid any interference.• When a hard rubber frame is mountedDo not use with the panel slid in the forwarddirection.If so, the hard rubber frame will interfere with thepanel when the angle is adjusted downward.• No sound is produced while the panel is operating.3 Select the displayPress the [5] ("OUT") button."Disp Out Select" is displayed.Each time the button is pressed the displayswitches.4 Exit display control modePress the [6] ("RTN") button.