50 | EnglishMenu systemIn Standby modePanel action settingSets the panel movement when the panel action(back/forward movement) is set to its most endposition.Display Setting"Panel Control:1" No angle can be adjusted if the panel positionhas been set to its most end position. Also, if youhave set the angle below the horizontal position,the angle is set to horizontal when you set thepanel to its most end position."Panel Control:2" The angle can be adjusted regardless of thepanel position.Function of the KDC-W8027System Q SettingSetting whether the display indicates the SystemQ factors (Bass center frequency, Bass Q factor,Bass extend, Middle center frequency, MiddleQ factor, and Treble center frequency) in Audiocontrol.Display Setting"System Q: ON" The System Q factors are displayed."System Q: OFF" The System Q factors aren’t displayed.Function of the KDC-PSW9527/KDC-W9027Audio SetupSwitches between the Easy mode and PRO mode(for detailed setup) during Audio setup.Display Setting"Audio Setup:Easy" Selects the quick Audio setup."Audio Setup:PRO" Selects the detailed Audio setup.• Refer to 'Audio Setup (Easy)' (page 28) and 'AudioSetup (PRO)' (page 30)."Audio Setup:Easy" : [CABIN] [SP-SEL] [SP-LEV] [CALL]"Audio Setup:PRO" : [X’over] [DTA] [EQ] [SP-LEV][MEMORY] [CALL]In Standby modeBuilt-in Amp Mute SettingToggles ON or OFF the mute control on the built-in amplifier.Turning ON this control enhances the preoutquality.Display Setting"AMP Mute: OFF" The built-in amplifier activates."AMP Mute: ON" The built-in amplifier deactivates.B.M.S. (Bass Management System)Adjust the bass boost level of the externalamplifier using the main unit.Display Setting"AMP Bass: Flat" Bass boost level is flat."AMP Bass: +6" Bass boost level is low (+6dB)."AMP Bass: +12" Bass boost level is mid (+12dB)."AMP Bass: +18" Bass boost level is high (+18dB).• Refer to the catalog or instruction manual for poweramplifiers that can be controlled from this unit.• For amplifiers there are the model that can be setfrom Flat to +18 dB, and the model that can be setfrom Flat to +12 dB.When an amplifier that can only be set to +12 isconnected to the unit, "AMP Bass: +18" won’t workcorrectly even if it’s selected.B.M.S. Frequency OffsetSetting the central frequency boosted by B.M.S.Display Setting"AMP FRQ: Normal" Boost with the normal central frequency."AMP FRQ: Low" Drop the normal central frequency 20%.