4-28 Keysight B2900 User’s Guide, Edition 5Front Panel ReferenceConfig key groupOutput Connection dialog boxThis dialog box provides the following parameters for setting the channel operationand connection.Ch Only on 2-channel models. Channel 1 (Ch 1) or2 (Ch 2)This field specifies the channel set by thisdialog box.Sensing Type Sensing type, 2-wire connection (2-WIRE) or4-wire connection (4-WIRE). Set 4-WIRE forremote sensing.Low Terminal State Low sense terminal connection,grounded (GROUND) or floating (FLOAT)High Capacitance Mode High capacitance mode, ON or OFFSet the mode to ON to perform high capacitiveload measurements. See “High CapacitanceMode” on page 6-15.Over Voltage/Current Protection Over voltage or current protection, ON or OFFSet the function ON to turn off the channeloutput automatically and immediately when itreaches its compliance.Output-Off State Output-off state, high impedance (HIGH Z),normal (NORMAL), or zero volt (ZERO)This is the source setup condition after outputoff. See Table 6-1 on page 6-13.Auto Output-On Automatic output on function, ON or OFFSet the function ON to turn on the channeloutput automatically just before the triggersystem is initiated by the SCPI command (notby front panel operation).Auto Output-Off Automatic output off function, ON or OFFSet the function ON to turn off the channeloutput automatically and immediately when alltrigger system changes the status from busy toidle.
