Keysight B2900 User’s Guide, Edition 5 6-31Function DetailsTrigger SystemTrigger OutputB2900 can output trigger at the timing of Trigger output shown in Figure 6-8. Thetrigger output terminal can be selected from the following terminals.• Internal bus, INT1, INT2• LAN port• Digital I/O pin, EXT1, EXT2, EXT3, EXT4, EXT5, EXT6, EXT7, EXT8,EXT9, EXT10, EXT11, EXT12, EXT13, EXT14The trigger output can be set by using “Trigger Configuration dialog box” on page4-38. The trigger output timing and the setup parameters are shown in Table 6-5.Table 6-5 Trigger Output Timing and Setup ParametersFor using a digital I/O pin, it is necessary to set function of the pin, output triggerpolarity, type, pulse width, and the Output Trigger Timing parameter. See “DIOConfiguration dialog box” on page 4-48 and “Using Digital I/O” on page 3-34.Trigger output timing Layer Action TriggerOutputOutputTriggerTimingStarting ARM loop ARM TRANS. fortransientaction orACQ. foracquireactionON BEFOREEnding ARM loop ARM ON AFTERStarting TRIGGER loop TRIGGER ON BEFOREEnding TRIGGER loop TRIGGER ON AFTERStarting Transient device action ACTION TRANS. ON BEFOREEnding Transient device action ACTION TRANS. ON AFTERStarting Acquire device action ACTION ACQ. ON BEFOREEnding Acquire device action ACTION ACQ. ON AFTER
