107Keysight InfiniiVision 2000 X-Series OscilloscopesUser's Guide7 Serial DecodeSerial Decode Options / 107Lister / 108Searching Lister Data / 110Digital channels and serial decode cannot be on at the same time. The [Serial] keytakes precedence over the [Digital] key. Serial triggers can be used when digitalchannels are on.Triggering onSerial DataIn some cases, such as when triggering on a slow serial signal (for example, I2C,SPI, CAN, LIN, etc.) it may be necessary to switch from the Auto trigger mode tothe Normal trigger mode to prevent the oscilloscope from Auto-triggering andstabilize the display. You can select the trigger mode by pressing the[Mode/Coupling] key, then the Mode softkey.Also, the threshold voltage level must be set appropriately for each sourcechannel. The threshold level for each serial signal can be set in the Signals Menu.Press the [Serial] key, then the Signals softkey.Serial Decode OptionsKeysight's hardware-accelerated serial decode options can be installed when theoscilloscope is manufactured, or added later. The following serial decode licensesare available:• With the DSOX2AUTO license, you can decode CAN (Controller Area Network)and LIN (Local Interconnect Network) serial buses. See:• “CAN Serial Decode" on page 305.• “LIN Serial Decode" on page 312.
