250 Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide20 Utility Settings5 Configure the oscilloscope's LAN interface:a Press the Addresses softkey.b Use the Mod ify softkey (and the other softkeys and the Entry knob) to enterthe IP Address, Subnet Mask, Gateway IP, and DNS IP values. When you aredone, go back up in the menu hierarchy.c Press the Host name softkey. Use the softkeys and the Entry knob to enter theHost name. When you are done, go back up in the menu hierarchy.d Press the Apply softkey.6 Connect the oscilloscope to the local area network (LAN) by inserting the LANcable into the "LAN" port on the rear panel of the oscilloscope.Stand-alone (Point-to-Point) Connection to a PCThe following procedure describes how to establish a point-to-point (stand alone)connection to the oscilloscope. This is useful if you want to control theoscilloscope using a laptop computer or a stand-alone computer.1 Press [Utility] > I/O.2 Press the LAN Settings softkey.3 Press the Config softkey; then, turn the Entry knob to select Automatic, and pressthe softkey again to enable it.If your network supports DHCP or AutoIP, enabling Automatic lets theoscilloscope use those services to get its LAN configuration settings4 Connect your PC to the oscilloscope using a cross-over LAN cable such asKeysight part number 5061-0701, available on the web atwww.parts.keysight.com.5 Cycle power on the oscilloscope. Wait until the LAN connection is configured:• Press [Utility] > I/O and wait until the LAN status shows "configured".This may take a few minutes.Now, the instrument is connected, and the instrument's web interface or remotecontrol via LAN may be used.
