Utility Settings 20Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide 263To configure the [Quick Action] key:1 Press [Utility] > Quick Action > Action; then, select the action that should beperformed:• Off — disables the [Quick Action] key.• Quick Measure All — displays a popup containing a snapshot of all the singlewaveform measurements. The Source softkey lets you select the waveformsource (which also becomes the source selection in the MeasurementMenu). See Chapter 14, “Measurements,” starting on page 181.• Quick Print — prints the current screen image. Press Settings to set up theprinting options. See Chapter 19, “Print (Screens),” starting on page 241.• Quick Save — saves the current image, waveform data, or setup. Press Settingsto set up the save options. See Chapter 18, “Save/Recall (Setups, Screens,Data),” starting on page 229.• Quick Recall — recalls a setup, mask, or reference waveform. Press Settings toset up the recall options. See Chapter 18, “Save/Recall (Setups, Screens,Data),” starting on page 229.• Quick Freeze Display — freezes the display without stopping runningacquisitions or un-freezes the display if currently frozen. For moreinformation, see “To freeze the display" on page 117.• Quick Trigger Mode — toggles the trigger mode between Auto and Normal, see“To select the Auto or Normal trigger mode" on page 148.• Quick Clear Display — clears the display, see “To clear the display" onpage 116.Once the [Quick Action] key is configured, you simply press it to perform theselected action.Adding an AnnotationYou can add an annotation to the upper left corner of the oscilloscope's display.The annotation is useful for documentation purposes, to add notes beforecapturing screens.To add an annotation:1 On the oscilloscope's front panel, press [Utility].2 In the Utility Menu, press Annotation.
