571APPENDIX B DEVELOPMENT TOOLSB.2 PROM Programming ToolB.2.1 HardwarePG-1500 This is a PROM programmer capable of programming the single-chip microcontroller with on-chipPROM programmer PROM by manipulating from the stand-alone or host machine through connection of theseparately available programmer adapter and the attached board. It can also program separatePROM ICs with a capacity from 256 Kbits to 4 Mbits.PA-78P054GC This is a PROM programmer adapter for theμPD78P058F, 78P058FY, and is used connected toPROM programmer the PG-1500.adapter PA-78P054GC: 80-pin plastic QFP (GC-3B9, GC-8BT type)B.2.2 SoftwarePG-1500 controller This program controls the PG-1500 from the host machine through serial and/or parallel interfacecable(s).The PG-1500 controller is a DOS-based application. When using Windows, start it from the DOSprompt.Part Number:μS××××PG1500Remark ×××× of the part number differs depending on the host machine and OS used. Refer to the table below.μS××××PG1500×××× Host Machine OS Supply Media5A13 PC-9800 Series MS-DOS 3.5-inch 2HD FD(Ver. 3.30 to 6.2Note)7B13 IBM PC/AT and Refer to B.4 3.5-inch 2HC FDcompatiblesNote The task swap function cannot be used with this software although this function isprovided in MS-DOS version 5.0 or later.
