CHAPTER 3 TERMINALSIssue 5UNIVERGE NEAX 2000 IPS General Description Page 207Command script interface allows an external application to communicate with the2000 IPS system via MATWorX based on the PBX script data. The externalapplication is System Programming Assistant (SPA) which is developed by PBC. Thisapplication complements the MATWorX to provide GUI-based system dataprogramming.Release 12.2: MATWorX IPS Ver. 11.6.0The list of MATWorX Add-Ins, which is enhanced to support the R12.2 related features:Service Restriction Add-inStation Assignment Add-inStation Data Copy / Move / Swap Add-inDigit Conversion Add-inNumbering Plan Add-inTraffic Measurement Add-inOffice Data Save / Load / Verify Add-inTrunk Route Add-inSetting System Accommodation Data Add-inMOC Mode Add-inMATWorX PC Requirements:Minimum Requirements Recommended ConfigurationCPU Pentium II 350MHz Pentium IV 1GHzRAM 128MB 256MBHard Disk 230MB or moreMonitor SVGA (800 x 600)High Color (16 bit)SVGA (1024 x 768)True Color (32 bit)15-inch or larger monitorPeripherals CD-ROM drive, Keyboard, MouseRS-232C or LAN interfaceOperating System Microsoft Windows Me, Windows 2000,Windows XP, Windows 2003(Latest Service Pack (SP) should be applied)6.5.4.4 Traffic managementThe SOPHO 2000 IPS provides traffic management reports to be used for overall analysisof system performance. MATWorX is used to request and display the type of report,sample measurement time period, and time increments of reports. There are over twentytypes of reports.6.5.4.5 Remote MaintenanceThis feature allows station and trunk changes or reassignments to be performed without asite visit by service personnel, and can be used to retrieve fault codes prior to visiting asite. One Remote Maintenance center can service an unlimited amount of systems, thusreducing the amount of personnel to maintain each site, travel costs and customer billingfor each site.Service Conditions1. The following additional equipment is required for this feature: