CHAPTER 3 TERMINALSIssue 5UNIVERGE NEAX 2000 IPS General Description Page 211By command entry from the MATWorX in the main site, the MP software stored in theexternal FTP server is downloaded to the MP of the remote site PIM. The downloadedsoftware stored in the MP is changed over to the existing working MP software. Bysystem data programming, below operation patterns are available.· Scheduled downloading & scheduled changeover· Immediate downloading & immediate changeover· Immediate downloading & scheduled changeoverIf the changeover fails, fallback to the old software can be executed in below patterns.· Automatic fall back (in case that system reset occurs 5 times in 3 minutes)· Manual fall back (by command data entry from MATWorX)· Scheduled fall backThe FTP server can be located in the main site or in each remote site.6.5.5 Diagnostics6.5.5.1 Log Data Collection for VoIP Calls (R10)This feature allows speeding up the isolation of an error as it provides functions foranalyzing VoIP related problems. Collects call logs and fault logs on VoIP calls. Thisenables the collected call log to be checked when the user reports a malfunction. Enablereal time check when a malfunction exists at registration or accumulated checking of errorinformation by a maintenance person. Call logs and Fault logs can be referenced fromMATWorX and MAT/CAT mode.Required Software and Hardware:- SPN-8IPLA IP PAD-C or firmware upgrade required.6.5.5.2 On-line MP-FP Command Output via RS-232 (R12.2)Prior to R12.2, MP-FP traces can be retrieved during off-line mode. In R12.2, the MP-FPtraces can be retrieved during on-line mode (SENCE switch=4), by entering commands(CMF6, Y=2). The traces data can be retrieved by MATWorX or can be output via RS-232C (Modem built into MP).Requires MATWorX IPS Ver.11.6.0 or later version.6.5.5.3 Self Diagnostic/System MessagesThe SOPHO 2000 IPS provides a sophisticated array of self-diagnostic routines that arecontinually and automatically being performed. Various system messages are printed
