CHAPTER 3 TERMINALSIssue 5UNIVERGE NEAX 2000 IPS General Description Page 9411 It’s a small world Not Available4.7 Firmware Processor (FP) CardFirmware processors (FP) are required when more than 2 PIMs are used. For a 1 or 2 PIMconfiguration a Firmware processor is not required as this is standard availablefunctionality on the SPN-CP24B and SPN-CP27A.The firmware processor provides supervision and status analysis of Line/Trunk (LT) portsthat reside in the PIM. The FP card is installed in slot 12 of PIM 2, 4 and 6.For the IPS DMR the maximum configuration consists of 2 PIMs.The FP card is installed in slot 12 of PIM 2 of a DMThe following firmware processor is available for the SOPHO 2000 IPS/DM12NC DescriptionRe lease2000 IPSIPS DMIPS DMRFunction960051151243 SPN-CP32 FP (PBC) X X - FIRMWARE PROCESSOR• Required when 3 or more PIM’s are mounted• DM = Max 1 card per system, mounts in third PIM(PIM 2).• IPS= Max 3 cards per system, One each mounts inthird PIM (PIM 2), fifth PIM (PIM 4) and seventh PIM(PIM 6).4.8 Line and Trunk (LT) CardsLine / Trunk (LT) cards are listed in the following sections, LT cards resides directlyunder the control of the FP of the associated PIM. The following conditions apply (2000IPS):Max. 512 ports per systemMax. 64 ports per PIMMax.128 ports per FPThe number of allowed LT ports is controlled by licenses.4.8.1 Analogue stationCards for analogue lines:
