General Product Description Sopho 2000IPS Release 12.2, August 2006NEC Philips Unified Solutions UPD 21 of 259© NEC Philips Unified Solutions, 2006. All right reserved.Reproduction in whole or in part is prohibited without the written consent of the copyright owner.1.4.7 Extended Application Processor (AP) Port CapacityThe SOPHO 2000 IPS provides maximum 256 AP ports and it is independent of the 1020ports for the Line/Trunk (LT), therefore, more AP cards such as T1/E1 digital link cardscan be used in the system.1.4.8 Office Data Backup EnhancementThe office data of the SOPHO 2000 IPS is stored in Flash ROM; therefore the backupperiod is extended compared to systems using RAM with battery.1.4.9 Various Installation MethodsTo meet the specific needs of the customer’s environment, the SOPHO 2000 IPS providesthe following installation methods:- Floor Standing Installation- Wall-mounting Installation- IEC standard 19 inch Rack-mounting Installation1.4.10 Station to Station ConnectionFor DtermIP to DtermIP connection (Peer to Peer connection), the voice data istransmitted and received directly between DtermIPs on the LAN. For Dterm Legacyterminal connection, the IPPAD card and VCT card are required to transmit and receivethe voice data. These cards are used to control and convert the voice data. The MP card ineither of the connections above manages the control signals.1.4.11 CCIS ConnectionDtermIP to DtermIP connection (Peer to Peer connection) via CCIS is available onlywhen the destination office is SOPHO 2000 IPS or SV7000.The DtermIP connection via CCIS is Peer to Peer to the ISG (IP interface card) in theiS3000.The system provides only Point to Multipoint connection.1.4.12 MaintenanceMATWorX IPS is used as the maintenance program for the SOPHO 2000 IPS. Directconnection (RS-232C), Modem connection and LAN (TCP/IP) connections are availableto connect to the MAT (Maintenance Administration Terminal).1.4.13 Dual MP SystemThe system complies with dual control system on Main Processor.Note: Since the system employs Cold Standby processing in MP changeover, the calls inprogress are terminated as a result of the MP changeover. Also, during the MPchangeover, the call originating/receiving and service feature access are noteffective. (It takes about 30 to 60 seconds to complete the MP changeover.)1.4.14 Remote PIM over IP with SurvivabilityThe SOPHO 2000 IPS can have a PIM installed at a remote site through an IP network.At the main site, the SOPHO 2000 IPS/IPS DM is installed and SOPHO 2000 IPS /IPSDMR are installed at the remote site. The main site controls call processing and servicefeature access for station users located at both the main and remote sites. When the
