General Product Description Sopho 2000IPS Release 12.2, August 2006NEC Philips Unified Solutions UPD 52 of 259© NEC Philips Unified Solutions, 2006. All right reserved.Reproduction in whole or in part is prohibited without the written consent of the copyright owner.On-line Moves, Adds and ChangesWhen LC/DLC/COT cards are added or deleted (Moves Adds & Changes- MAC) inRemote Site through on-line programming these cards are in real time being assigned tothe system, even if the system data copy is not activated to the Remote site.2.15.2 Remote PIM over IP System ConditionsGeneral Conditions- The same version of software must be installed in the MP cards of Main and RemoteSites.- The way of loading and conditions of Key FD are following.o The same number of Key FD for remote site license as the number of remote sitesis required for Remote PIM over IP system. The required Key FD for the wholesystem must be loaded to the Main Site.o Total number of terminals that can be accommodated in the Remote Site dependson the number of port and number of license allocated from total Key FD data ofMain Site. The total Key FD data is loaded to Main Site and divided betweenMain Site and Remote Sites as following examples.Example 1: When 256-port Key FD is loaded to the Main Site and 64 ports areused in the Remote Site. Remote Site: 64 ports are allocated from theMain Site. Main Site: 192 ports are availableExample 2: When 128-IP license Key FD is loaded to the Main Site. The licenseis allocated in order of connecting IP telephone regardless of MainSite or Remote Site.o After Key FD data is loaded to the Main Site, the service feature, number of port,and number of license to be used by each Remote Site are sent to the flashmemory of each Remote Site’s MP card automatically. When Remote Sitesoperate with survival mode, this data is used.o Data to be used by each Remote Site is stored in the flash memory every 10minutes. When a Remote Site starts operating with survival mode within 10minutes from starting up, the system does not operate normally because the data isnot stored in flash memory. The system should be observed for more than 10minutes after starting up.o The number of legacy terminal that depends on the number of PIM in TDSWsystem depends on the number of port in Remote PIM over IP system. For KeyFD data, one PIM license for TDSW system is converted to 64 ports for RemotePIM over IP system.- The number of accommodated terminals/trunks in Main Site and Remote Site shouldbe a maximum of 1020 ports in the whole system.- The TCP/IP network is required between Main Site and Remote Site. The closed andbandwidth guaranteed network is preferable, such as IP-VPN (Layer 3 VPN) or widearea Ethernet service (Layer 2 VPN). The following table shows the permissible delaytime in the network.Permissible delay timeRecommended/Maximum Value One-way Return-wayRecommended 100 ms. 200 ms.Maximum Value 120 ms. 240 ms.
