General Product Description Sopho 2000IPS Release 12.2, August 2006NEC Philips Unified Solutions UPD 34 of 259© NEC Philips Unified Solutions, 2006. All right reserved.Reproduction in whole or in part is prohibited without the written consent of the copyright owner.2.3.2 Battery Module (BATTMH)The BATTMH is an optional module for installing optional long-term (about 3 hours)backup batteries. The BATTMH is designed to accommodate batteries covering up to onestack of a 4-PIM system (2 BATTMHs support maximum system configuration).The BATTMH is available for Floor Standing Installation. When the system is Wall-mounting/19 inch Rack-mounting configuration, the BATTMH cannot be installed withthe PIM.2.3.3 Installation HardwareBase/Top Assembly(1 per stack)The Base/Top Assembly includes a Base Unit and a Top Coverfor the PIM. One Base/Top Assembly is required for each PIMstack. The Base Unit also serves as the AC power distributionpanel for up to a four PIM configuration.Hanger Assembly(1 per PIM)The Hanger Assembly is used for Wall-mounting Installation.One set of Hanger Assembly is required for each PIM.19 inch Bracket(A: 1 per PIM)(B: 1 per stack)The 19-inch Bracket is a set of hardware used for 19-inchRack-mounting Installation.The 19-INCH RACK BRACKET (A) is installed on both sidesof the PIM. One set of 19 inch Bracket (A) is required for eachPIM.The 19-INCH RACK BRACKET (B) is installed at the BASEof stack. One 19-INCH BRACKET (B) is required for eachstack.If the system is 2 PIM or more configurations with 19-INCHBRACKET (B), one set of 19-INCH BRACKET (A) is alsorequired for the topmost PIM.Mounting Bracket(Optional 1 per stack)This is used for Floor Standing Installation. Without MountingBracket, 1.1 G shockproof is provided for 1 to 3-module stackand 0.5G shockproof is provided for 4 or more module stack.To enhance the shockproof capability to 1.1 G, one set ofMounting Bracket is required for each 4 or more module stackand attached to the topmost PIM.I/F Bracket(Optional 1 persystem)This is used for Floor Standing Installation to joint theneighboring topmost PIM in 6 PIM or more configurations.One set of I/F Bracket is required for multiple stacks.Base Tray Assembly(Optional 1 per stack)This is used for Floor Standing Installation for stationaryequipment (UL complied). One set of Base Tray Assembly isrequired for each stack.
