General Product Description Sopho 2000IPS Release 12.2, August 2006NEC Philips Unified Solutions UPD 49 of 259© NEC Philips Unified Solutions, 2006. All right reserved.Reproduction in whole or in part is prohibited without the written consent of the copyright owner.2.14.2 SOPHO IPS DML/ IPS DMR Modular Chassis (MC)The SOPHO 2000 IPS DML/IPS DMR consists of from one to two Modular Chassisdepending on the system configuration. There are 2 types of Modular Chassis; "PhysicalModular Chassis" and "Virtual Modular Chassis ".The Physical Modular Chassis is “hardware Modular Chassis” and is used toaccommodate an MP, IP PADs, legacy LT/AP cards, and power supply units. ThePhysical Modular Chassis provides 56 LT ports in hardware slots and provides 64 ports insoftware port allocation (56 LT ports and 8 virtual ports). One Modular Chassis provides8 card slots including one card slot for Main Processor (MP) and other 7 slots for LineTrunk (LT)/Application Processor (AP) cards; 56 LT ports and 8 virtual LT ports; AC,LTC, BUS cable connectors and power switch which are located at the rear side ofModular Chassis. The Physical Modular Chassis can be installed on the desktop or intothe 19-inch rack only.The Virtual Modular Chassis is a “software Modular Chassis” with a port capacity of 64ports. A maximum of two Virtual Modular Chassis can be assigned per IPSD ML/IPSDMR for a total of 128 ports used to accommodate IP stations by system dataprogramming.The SOPHO IPS DML is an SOPHO 2000 IPS DM that has been optimized for SmallOffice Stand Alone IP Solution with from 10 to 80 IP telephones. The SOPHO IPS DMLuses the SPN-CP31 as the Main Processor. This system targets users with up to 112 TDMstation, 128 IP stations and can be used as an end point in a peer-to-peer CCIS network.The following options that are built-in on the CP24 are not available with the CP31:- No built-in DAT- Only one RS Port- No built-in DK (external/relay key)- No MN Alarm IndicationThe SOPHO IPS DMR locates the maximum of 64 FP/AP cards per system, at multipleRemote Sites. The number of FP/AP cards accommodated at one Remote Site should be amaximum of eight including the MP built-in FP. If more than eight FP/APs are assigned,the system does not operate normally. The maximum number of Remote Sites is 30. TheMP card at Remote Site has the same system data as that at Main Site, because RemoteSite automatically gets the data from Main Site at the time of setup. In normal operation,Main Site automatically copies the system data to Remote Site through the network oncea day. Because the CP31 is a cost down CPU, the following options that are built-in onthe CP24 are not available with the CP31:- No built-in DAT.- Only one RS Port.- No built-in DK (external/relay key).- No MN Alarm IndicationThe following illustration shows Modular Chassis hardware configurations, software portallocation, face layout and rear view of Modular Chassis for The SOPHO IPS DML/IPSDMR.
