Forced Unscreened TransferUX Mail Manual Chapter 2: Features ◆ 1452Forced Unscreened TransferDescriptionA Subscriber Mailbox can optionally convert Automated Attendant Screened Transfers to UnscreenedTransfers. Enable this option for a mailbox if the subscriber prefers to receive all calls sent by the AutomatedAttendant as Unscreened Transfers. With Unscreened Transfers:● Calls from the Automated Attendant ring like other transferred calls and display the incoming Caller IDdata (if provided by telco and enabled in programming) as the call is ringing.● As with Screened Transfers, unanswered calls route to the subscriber’s greeting (recorded or default) sothe caller can leave a message. However, with Unscreened Transfers the caller cannot dial 2 to reach theNext Call Routing Mailbox options (if programmed).Related FeaturesDial Action Table (page 116)If enabled in the Subscriber Mailbox, voice mail automatically converts any Screened Transfers (TRFs)to the subscriber’s extension to Unscreened Transfers (UTRFs).Screened Transfer (page 270)After the Automated Attendant caller dials an extension, voice mail calls (screens) the destination exten-sion to see if the transfer can go through.Unscreened Transfer (page 299)After an Automated Attendant caller dials an extension, voice mail immediately transfers the call to theextension and hangs up.ProgrammingStep 1 Enable Forced Unscreened Transfer for the Subscriber Mailbox.1.1 CUSTOMIZE : M AILBOX O PTIONS E DIT : SUBSCRIBER : [L AMP /LOGON /TRANSFER ] FORCED UNSCREENED TRANS -FER ( PAGE 433).- Enable (check) this option to automatically convert Automated Attendant Screened Trans-fers to Unscreened Transfers.✔ By default, this options is disabled (No). Voice mail processes Automated AttendantScreened Transfers to the subscribers extension normally.OperationN/A
