Xen Topaz Programming Manual 5Introduction to ProgrammingBefore you Start ProgrammingUsing Keys to Move Around in the ProgramsOnce you enter the programming mode, use the keys in the following chart to enter data, edit dataand move around in the menus.♦Keys for Entering DataUse this Key….. When you want to …..0-9, *, # Enter data into a program.HOLD Complete the programming step you just made (like pressing Enter on a PCkeyboard). When a program entry displays, press HOLD to bypass the entrywithout changing it.CONF Delete the entry to the left (like pressing Backspace on a PC keyboard).DC Exit one step at the time from the program window currently being viewed.For example, if you’re programming item 5 in 15-03, pressing DC will allowyou to enter a new option in program 15-03. Pressing DC again will allow youto select a new program in the 15- series. Pressing DC a third time will allowyou to enter a new program beginning with ‘1’. Pressing DC one last time willbring you to the beginning program display, allowing you to enter any pro-gram number.FLASH Switch TEL (extension), Trunk (line), etc. being programmed by pressingFLASH. The cursor moves up to the upper row of the display. PressingFLASH again moves the cursor back to the lower row.VOL.UP Scroll backward through a list of entry numbers (e.g., from extension 10 to11, 13, etc.) or through entries in a table (e.g., Common Permit Table).If you enter data and then press this key, the system accepts the data beforescrolling forward.VOL.DOWN Scroll forward through a list of entry numbers (e.g., from extension 200 to201, 203, etc.) or through entries in a table (e.g., Common Permit Table).If you enter data and then press this key, the system accepts the data beforescrolling backward.CHECK Change an alphabetic character / numberCLEAR Delete all digitsLND Move the cursor to the leftOPAC Move the cursor to the rightSPK Exit the Programming Mode
