Program 40 to 92Xen Topaz Programming Manual 275PROGRAM 44: ARS/F-ROUTE SETUP44-02: SYSTEM OPTIONS FOR ARS/F-ROUTEDescriptionUse Program 44-02 : Dial Analysis Table for ARS/F-Route Access to set the Pre-Transaction Table forselecting ARS/F-Route.• Service Type 1 (Extension number)The number goes to an extension after deleting the front digit(s).Additional dataAssign the digit(s) to be deleted on top of the number for extension number usage. There must be at leastone digit deleted.• Service Type 2 (ARS/F-Route select)The number is controlled by ARS/F-Route table.Additional dataAssign the ARS/F-Route table number for Program 44-05. (If the ARS/F-Route Time schedule is not used.)Assign the ARS/F-Route selection number for Program 44-04. (If the ARS/F-Route Time schedule is used.)• Service Type 3 (Dial Extension Analyze Table select)The total length of the number exceeds more than 5 digits.Additional dataAssign the referring Dial Extension Analyze Table number for Program 44-03.Input DataINSASBDial Analysis Number 1-120Prog. No. Item Input Data Default RelatedProgram44-02-01 Dial Up to 4 digits No setting44-02-02 Service Type 0 : No setting1 : Select Extension Call2 : Select ARS/F-Route Access3 : Select “Dial Extension Analyze Table”044-02-03 Additional Data • When Select 1 (Select Extension Call)from 44-02-02 : 0-255 (Delete Digit)(255 : delete all digit)044-0144-02-02• When Select 2 (Select ARS/F-RouteAccess) from 44-02-02 :- Not Used F-Route Time Schedule[Program 44-01 : 0]0-500 (ARS/F-Route table Number)(0 : No setting)- Used F-Route Time Schedule[Program 44-01 : 1]0-500 (ARS/F-Route select table Num-ber) (0 : No setting)• When Select 3 (Select “Dial ExtensionAnalyze Table”) from 44-02-02 :0-4 (Dial Extension Analyze TableNumber) (0 : No setting)44-02-04 Dial Tone Simulation 0 : Off1 : On0
