Program 21 to 25Xen Topaz Programming Manual 212PROGRAM 25: DID/DISA S ETUP25-07: SYSTEM TIMER FOR DID/DISA/VRSDescriptionUse Program 25-07 : System Timers for DID/DISA/VRS to set the value for the system timers which af-fect DID and DISA. Refer to the following chart for a description of each option, its range and default set-ting.Input DataINSASBProg. No. Item Input Data Default RelatedProgram25-07-01 DISA/VRS Dial Tone TimeAfter answering a DISA/VRS trunk, the system waits thisinterval for the caller to dial the first digit of the DISA pass-word. If the caller fails to dial within this interval, the systemdrops the call0-64800(sec)0 = Off 10 22-0225-0425-07-02 DID/DISA No Answer TimeA DISA caller can ring an extension for this intervalbefore the system sets the call as a Ring No Answer.After this interval expires, the call follows the programmedRing No Answer routing (set in Program25-03 and 25-04).0-64800(sec) 10 25-0425-07-03 Disconnect after DID/DISA re-transfer to IRG 0-64800(sec) 6025-07-04 Calling Time to Automatic answering Telephone set 0-64800(sec) 1025-07-05 Duration time for Guidance Message by Automaticanswering telephone set 0-64800(sec) 1025-07-06 Duration time for Guidance Message by ACI Talkie 0-64800(sec) 1025-07-07 DISA Conversation Warning Tone TimeDetermine the length of time a DISA caller can talkbefore the Long Conversation tone is heard.0-64800(sec) 180025-07-08 DISA Long Conversation DisconnectThis timer determines how long the system will waitbefore disconnecting a call after the Long Conversationtone is heard.0-64800(sec) 3025-07-09 DISA Internal Paging TimeThis is the maximum length of an Internal Page placed by aDISA caller. If the Page continues longer than this interval,the system terminates the DISA call.0-64800(sec) 3025-07-10 DISA External Paging TimeThis is the maximum length of an External Page placed by aDISA caller. If the Page continues longer than this interval,the system terminates the DISA call0-64800(sec) 3025-07-11 DID/DISA/VRS Answer Delay Timer 0-64800(sec) 025-07-12 -Not Used- - -25-07-13 DID/DISA Busy Tone IntervalIf a DISA caller dials a busy extension (and Program25-04 = 0), the system plays busy tone for this intervalbefore disconnecting.0-64800(sec) 525-07-14 Delayed DID Answer TimerAssign the delay time from switching from a normalincoming status to DID mode. If this time is set to ‘0’,the call will switch to DID mode immediately.0-64800(sec) 10 22-02
