Chapter 11 Adding Lines and Annotations to an Image129Adding Annotationsand Measuring11.2 Changing Scaling and Measurement Settings— TOOL SET Menu —Scaling and measurement can be configured using the [TOOL SET] button on the tool menu.1 Display the [TOOL MENU] screen.2 Press the [TOOL SET] button.The [TOOL SET] button appears.3 Press a desired button on the [TOOL SET] button toshow a desired setup menu.The menu changes as you select:• Main: [TOOL SET: MAIN] screen• Cross Hairs: [TOOL SET: X HAIRS] screen• Grid Line: [TOOL SET: GRID] screen• Calibration: [TOOL SET: CALIB] screen• Cancel Cancels selection.Operate the [MENU SELECT] button on each menu on[TOOL SET] to switch to another menu.4 Configure settings in each menu. If you see the [SAVE]button, press it to save the settings.Content of the setting for each screen is described in thefollowing pages.5 Press the [ TOOL] button to return to [TOOL MENU].Press the [X] button to close the menu.Switching Setup MenuTOOL setup menus[TOOL SET: MAIN]Configures basicsettings as well assaving settings withCSV files.[TOOL SET: X HAIRS]Cross hairs and circles.[TOOL SET: GRID]Sets up how to drawgrid lines and drawsgrid.[TOOL SET: CALIB]Registers calibration settings to be basic lengths formeasurement.Displaying [TOOL SET] menusYou cannot operate any annotation or measurement while a [TOOL SET] menu is displayed. [T.BAR] on the task baris grayed out, indicating that operation is restricted.213Switchsetup menu.
