Chapter 13 Changing Settings166ChangingSettings(2) Configuring the display mode of the internal LCD and external monitorSet the resolution of video signal to be output to the external monitor and ON/OFF of the internal LCD.1 Display the [SETUP MENU: MAIN] screen.2 Press the [DISPLAY MODE] button in the [DISPLAYSETTING] - [INTERNAL LCD] area.The [DISPLAY MODE] submenu appears.3 Select the display mode of the external monitor and theinternal LCD.For details of choice, see the table below.• [XGA / LCD ON] (initial setting)• [SXGA / LCD OFF]• [XGA / LCD OFF]When one of these has been selected, the submenu closesand the selected content is displayed in the [DISPLAYMODE] button.4 Press the [SAVE] button.A reboot request message for the DS-L3 appears.5 To switch the setting, turn off the DS-L3 and then turn iton.The display mode of the internal LCD and the externalmonitor switches.Configuring Display ModeChoice of Display ModeChoice SettingXGA / LCD ON Outputs XGA (1024 x 768) signal to the external monitor.The same video as the external monitor is displayed on the internal LCD. (Initial setting)SXGA / LCD OFF Outputs SXGA (1280 x 1024) signal to the external monitor.Nothing is displayed on the internal LCD.XGA / LCD OFF Outputs XGA (1024 x 768) signal to the external monitor.Nothing is displayed on the internal LCD.To reset display mode at startupIf the DS-L3 is turned on without connecting the external monitor with [SXGA / LCD OFF] or [XGA / LCD OFF] (internal LCDOFF setting) selected, nothing is displayed on the internal LCD disabling any operation in some cases.In this case, perform the following procedure to reset the display mode setting.1 Turn off the DS-L3.2 Press the power switch to turn on the DS-L3 and repress the power switch while the POWER indicator isblinking to turn off the DS-L3.After this operation, the [DISPLAY MODE] setting is changed to [XGA / LCD ON].3 Turn on the DS-L3.A screen is displayed on the internal LCD.When the [DDC I/F] checkbox is selectedWhile the [DDC I/F] checkbox is selected, the DS-L3 detects the external monitor connection status.If the DS-L3 is turned on without connecting the external monitor while the internal LCD monitor is set to OFF, theDS-L3 recognizes that no monitor is connected and automatically sets the internal LCD monitor to ON to start it.However, if the external monitor is disconnected after the DS-L3 is turned on, the internal LCD monitor is not set toON.In this case, turn off the power and reconnect the external monitor, and then turn on the power. Then the internalLCD monitor is automatically set to OFF.4312
