Instruction ManualNivuFlow Mobile 600page 20 NFM 600 - rev. 02 / 10.07.2019Delivery, Storage and Transport10 DeliveryThe standard delivery of the NivuFlow Mobile 600 basically contains:• Transmitter type NivuFlow Mobile 600 (according to shipping documents)• Ring magnet (solenoid)• USB stick• Screw driver for hexagon socket screws• PU stickers (two pieces: 31x17x3.5 mm) to avoid vacuum in the enclosure in case ofbeing returned (via airfreight) to NIVUS (e. g. for maintenance)• T-shape antenna (only for versions with internal GPRS / UMTS / LTE modem)• Padlock (only for Ex versions)• Instruction manual (incl. certificates of conformity) containing any relevant informationon how to operate the NivuFlowCheck extra accessories depending on your order and by using the delivery note.11 Reception inspectionCheck the packaging for visible damage immediately after receipt. Any possible damage intransit shall be instantly reported to the carrier. Furthermore a written report shall be sent toNIVUS GmbH in Eppingen.Incomplete deliveries shall be reported in writing either to your local representative or directlyto the NIVUS head office in Eppingen within two weeks.Important noteMistakes cannot be rectified later! Prior to the first use:1. Open enclosure cover.2. Remove both PU stickers (two pieces; 31x17x3.5 mm), if available, from the leftand right enclosure frame (Fig. 14-1 no. 1). The stickers have been attachedprior to shipping (via airfreight) to prevent the enclosure from getting closed andto avoid vacuum formation due to extreme temperature changes during ship-ping.
