Parameter SettingNFM 600 - rev. 02 / 10.07.2019 page 9739.5.6 Update NivuFlowUpload of a NivuFlow Mobile firmware saved on USB.39.5.7 Update BootloaderUpload of a bootloader software saved on USB.39.6 Storage ModeThe >Storage Mode< menu determines the >Operating Mode< and the >Storage Cycle<.Fig. 39-8 Storage Mode – Operating ModeOperating Mode, Storage Cycle, Event Type and Event IntervalThe operation mode determines when and how often the transmitter shall measure and whenand how often the measurements shall be saved. Storage cycle and event interval can be ad-justed depending on the operation mode.To choose the >Operation Mode< select from• >Cycle Mode<The transmitter wakes up at the intervals set in storage cycle, executes a brief meas-urement and saves the data. After that the transmitter goes back to “sleep mode” untilthe next measurement.• >Event Mode<On one hand, the transmitter behaves like being in cyclic operation, however it is possi-ble to additionally set an event interval. The transmitter then wakes up at previously de-fined events, measures and saves data at the adjusted event intervals.• >Continuous Event Mode<In this mode the transmitter basically operates like being event operation, howevermeasures continuously during the event. The instrument saves the data at the adjustedevent intervals.• >Continuous Operation<The transmitter measures continuously, however will save the data only at the intervalsset with the storage cycle.>Storage Cycle<Select from (depending on the operation mode set): (5 s, 10 s, 20 s, 30 s,) 1 min, 2 min,5 min, 10 min, 30 min and 1 h>Event Type< (only with Event mode and Continuous event mode)The operation modes “Event mode” and “Continuous event mode” allow to (depending on the
