A CCESS G ATEWAY134 System Administration4. Check the Subscriber Tracking Log save to file option to save the syslogs locally tothe NSE flash. Note: Not recommended.5. Check the Include User Name Reporting option to include the first 25 characters ofthe username in the Syslog.6. Check the Port Location: Include Port Reporting option and Port Location: IncludeLocation option to include the port information from the port location table and thePort reported to the system by either VLAN or SNMP query. The Locationinformation is limited to 25 characters.7. Check the Include every 500th Packet option to follow the Danish law that requiresthe 500th packet for each subscriber to be logged. Enabling this will send the 500 thpacket for each subscriber to the syslog system.Click on the Submit button to save your changes, or click on the Reset button if you wantto reset all the values to their previous state.When logging is enabled, log files and error messages are sent to these servers for futureretrieval. To see sample reports, go to “Sample SYSLOG Report” on page 314 and “SampleAAA Log” on page 313.Enabling MAC Authentication {MAC Authentication}1. From the Web Management Interface, click on Configuration, then MAC authentication.The MAC Authentication Settings screen appears:2. Check the MAC Authentication checkbox to enable the MAC-based authenticationfunctionality. The default setting is disabled.3. Enter the retry frequency (in seconds) in the Retry Frequency field. This setting is thewait time, in seconds, before reattempting MAC authentication following a failed attempt.The minimum (and default) value is 10 seconds.4. Select the MAC Address Format. This setting is the format in which the subscriber’sMAC address will be expressed in the RADIUS username and password attributes. The
