A CCESS GATEWAYInstalling the Access Gateway 67Tracking Log EnabledTracking Log Number 2Tracking Log Server IP 10.10.10.10Tracking Log Save to file DisabledTracking Name Reporting EnabledTracking Port Reporting EnabledTracking Location Reporting EnabledTracking Report every 500th packet EnabledWARNING: Communication between the gateway and the syslog server may need to besecured to comply with local laws. Consider routing communication through an IPSec tunnel.Configuration>Logging Out and Powering Down the SystemUse this procedure to log out and power down the Access Gateway.1. Enter l (logout) at the Access Gateway Menu. Your serial session closes automatically.2. Turn off the Access Gateway and disconnect the power cord.3. Disconnect the cable between the Access Gateway and your computer.Connecting the Access Gateway to the Customer’s NetworkUse this procedure to connect the Access Gateway to the customer’s network (after the start upconfiguration parameters have been established).1. Choose an appropriate physical location that allows a minimum clearance of 4cm eitherside of the unit (for adequate airflow).2. Connect the Access Gateway to the router, then connect the Access Gateway to thecustomer’s subscriber port.3. Connect the power cord and turn on the Access Gateway.4. Go to “Establishing the Basic Configuration for Subscribers” on page 67.Establishing the Basic Configuration for SubscribersWhen you have successfully established the start up configuration and installed the unit ontothe customer’s network, connect to the Access Gateway via Telnet. You must now set up thebasic configuration parameters for subscribers, including:
