A CCESS GATEWAYSystem Administration 2695. Enter the External IP Address.6. Enter the External Port reference.7. Optional: Enter the Remote IP Address. Leave this field set to zero if you want toconnect to the internal device from any network-side workstation.8. Optional: Enable the Protect with Source IP-based Access Control option. Enablingthis will only allow address in the source-based access control list to connect on this portmapping. Source-based access control needs to be enabled for this to be in effect.9. Optional: Enter the Remote Port reference. Leave this field set to zero if you want toconnect to the device from any TCP/UDP port of a network-side workstation.10. Select the protocol (TCP or UDP) from the pull-down menu.11. Click on the Add button to add this static port, or click on the Reset button to reset allvalues to their previous state.To delete static ports1. From the Web Management Interface, click on System, then Static Port-Mapping. TheStatic Port-Map screen appears:2. Select the item you want to delete.3. Click on the Delete button to delete the static port, or click on the Reset button to resetyour changes to their previous state.For more information about Static Port-Mapping, see also: “Displaying the Static Port Mapping Table {Static Port-Mapping}” on page 189Updating the Access Gateway Firmware {Upgrade}Upgrading the Access Gateway firmware is performed from the Access Gateway’s CommandLine Interface (CLI) only. Refer to the Firmware Upgrade Procedure (separate documentavailable from Nomadix Technical Support).The External IP address field will default to the IP address of the AccessGateway.
