E Series Automated Dispensing System36www.nordsonefd.com info@nordsonefd.com 800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.Setting System Parameters (continued)Pause Status (Tip Pause Location)When you press the START button on the front of the robot, the system stops dispensing and the tip stays at itscurrent location or moves based on the setting for Pause Status.NOTE: If the system is paused during dispensing, the system shuts off the dispenser, compromising patternintegrity.# Key Press Step Teach Pendant Display1> >• Press SETUP.• MOVE UP / DOWN to PAUSE STATUS.• Press ENTER.[SETUP] 2/308*Pause Status09 Auto Purge10 Pre-cycle Initialize11 Pre-dispense Wait Time12 Default Dispense Port13 Needle Detect Setup14 Run Limit2or >• Press 1 PARK POSITION to cause thetip move to the Park Position.• Press 2 STAND to cause the tip to stopat the next programmed position.• Press F1 to save or exit.Pause StatusPark Position------------------------------1 Park Position2 StandSelect: _[F1] OKPre-Cycle Initialize (Auto-Initialize)If Pre-cycle Initialize is enabled, the system automatically moves the dispensing tip to the Home Position andinitializes between each dispense cycle.# Key Press Step Teach Pendant Display1> >• Press SETUP.• MOVE UP / DOWN to PRE-CYCLEINITIALIZE.• Press ENTER.[SETUP] 2/308 Pause Status09 Auto Purge10*Pre-cycle Initialize11 Pre-dispense Wait Time12 Default Dispense Port13 Needle Detect Setup14 Run Limit2or >• Press 1 ENABLE to initialize betweendispense cycles.• Press 2 DISABLE for no initializationbetween dispense cycles.• Press F1 to save or exit.Pre-cycle InitializeDisable------------------------------1 Enable2 DisableSelect: _[F1] OK
