Using the Console Interface302401-D Rev 00 3-11• When the in-band IP address is not set from the console terminal, the switchbroadcasts BootP requests until it receives a BootP reply containing an IPaddress. If the switch does not receive a BootP reply that contains an IPaddress, the switch cannot be managed in-band.If an IP address is not currently in use, these actions take effect immediately. If anIP address is currently in use, these actions take effect only after the switch is resetor power cycled.BootP AlwaysAllows the switch to be managed only when configured with the IP addressobtained from the BootP server.When selected, this mode operates as follows:• The switch continues to broadcast BootP requests, regardless of whether anin-band IP address is set from the console terminal.• If the switch receives a BootP reply that contains an in-band IP address, theswitch uses this new in-band IP address.• If the switch does not receive a BootP reply, the switch cannot be managedusing the in-band IP address set from the console terminal.If an IP address is not currently in use, these actions take effect immediately. If anIP address is currently in use, these actions take effect only after the switch is resetor power cycled.BootP DisabledAllows the switch to be managed only by using the IP address set from theconsole terminal. When selected, this mode operates as follows:• The switch does not broadcast BootP requests, regardless of whether an IPaddress is set from the console terminal.• The switch can be managed only by using the in-band IP address set from theconsole terminal.These actions take effect after the switch is reset or power cycled, even if an IPaddress is not currently in use.kombk.book Page 11 Tuesday, June 29, 1999 3:25 PM
