Using the BayStack 450 10/100/1000 Series Switch3-20 302401-D Rev 00MAC Address TableThe MAC Address Table screen (Figure 3-7) allows you to view MAC addressesthat the switch has learned or to search for a specific MAC address.The MAC Address Table screen also operates in conjunction with the PortMirroring Configuration screen. When you configure a switch for MACaddress-based port mirroring, you can use the MAC Address Table screen to findan address, and enter the address directly from this screen. You can enteraddresses from either screen, but you must return to the Port MirroringConfiguration screen to activate the feature (see “Port Mirroring Configuration”on page 3-45).Choose MAC Address Table (or press m) from the Switch Configuration Menuscreen to open the MAC Address Table screen.Display Port Statistics Displays the Port Statistics screen (see “Port Statistics” on page 3-54).This screen allows you to view detailed information about any switchport.Clear All Port Statistics Allows you to clear all port statistics.This option is followed by screen prompts that precede a choice of theactions:• If the switch is operatingstandalone, choose one of the following:• Yes, to clear all port statistics for all switch ports• No, to abort the option• If the switch isparticipating in a stack configuration, choose one ofthe following:• Clear all port statistics for a specific unit in the stack• Clear all port statistics for the entire stack• No, to abort the optionReturn to Main Menu Exits the Switch Configuration Menu screen and displays the mainmenu.Note: This screen does not refresh dynamically to show new entries. Torefresh the screen, press [Ctrl]-R to return to the previous menu.Table 3-5. Switch Configuration Menu Screen Options(continued)Option Descriptionkombk.book Page 20 Tuesday, June 29, 1999 3:25 PM