Using the Console Interface302401-D Rev 00 3-65Renumber Stack UnitsThe Renumber Stack Units screen (Figure 3-26) allows you to renumber the unitsconfigured in the stack. When selected, this option identifies the unit number ofeach unit in the stack configuration by lighting the corresponding number of (100Mb/s port) LEDs on each unit for approximately 10 seconds. For example, unit 3will display three LEDs.Choose Renumber Stack Units (or press n) from the main menu to open theRenumber Stack Units screen.Figure 3-26. Renumber Stack Units ScreenNote: This menu option and screen only appear when the switch isparticipating in a stack configuration.Renumber Stack UnitsCurrent Unit Number MAC Address New Unit Number------------------- ---------------------------- ---------------[ 1 ] 00-60-fd-77-a6-0c [ 1 ][ 2 ] 00-60-fd-77-a5-f0 [ 2 ][ 3 ] 00-60-fd-77-a4-4c [ 3 ][ 4 ] 00-60-fd-77-ab-84 [ 4 ]Renumbering stack units will cause an automatic Reset to Current Settings tooccur across the entire stack. The current configuration will be adapted tothe new numbering scheme. Check the stack configuration after the reset toconfirm the desired configuration is set.Are you sure you want to renumber switches with the new settings? [ No ]Use space bar to display choices, press or to select choice.Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.kombk.book Page 65 Tuesday, June 29, 1999 3:25 PM
