Using the BayStack 450 10/100/1000 Series Switch3-76 302401-D Rev 00Table 3-27. TELNET Configuration Screen FieldsField DescriptionTELNET Access Allows a user remote access to the CI through a TELNET session.Default Value: EnabledRange: Enabled, DisabledLogin Timeout Specifies the amount of time a user has to enter the correct password at theconsole-terminal prompt.Default Value: 1 minuteRange: 0 to 10 minutes (0 indicates “no timeout”)Login Retries Specifies the number of times a user can enter an incorrect password at theconsole-terminal prompt before terminating the session.Default Value: 3Range: 1 to 100InactivityTimeoutSpecifies the amount of time the session can be inactive before it is terminated.Default Value: 15 minutesRange: 0 to 60 minutes (0 indicates “no timeout”)Event Logging Specifies the types of events that will be displayed in the Event Log screen (see “DisplayEvent Log” on page 3-85).Default Value: AllRange: All, None, Accesses, FailuresDescription:All: Logs the following TELNET events to the Event Log screen:• TELNET connect: Indicates the IP address and access mode of aTELNET session.• TELNET disconnect: Indicates the IP address of the remote hostand the access mode, due to either a logout or inactivity.• Failed TELNET connection attempts: Indicates the IP address ofthe remote host whose IP address is not on the list of allowedaddresses, or indicates the IP address of the remote host that didnot supply the correct password.None: Indicates that no TELNET events will be logged in the EventLog screen.Accesses: Logs only TELNET connect and disconnect events in theEvent Log screen.Failures: Logs only failed TELNET connection attempts in the EventLog screen.(continued)kombk.book Page 76 Tuesday, June 29, 1999 3:25 PM
