148 / Private networking using PRI SL-1Modular ICS 6.0 Installer Guide P0992638 03Remote systemOn the nodes that are not directly connected to the centralvoice mail system, you need to use the Telco Featuresheadings to identify the route to the voice mail system.1. After you enter your password, press ‘ until theprompt displays Telco Features:2. Press ≠. The prompt displays VMsg Centertel#s.3. Press ≠. The prompt displays VMsg Center 1.4. Press ≠. The prompt displays Use:.5. Press CHANGE to until you reach Routing tbl.6. Press ‘. The prompt displays Tel #:.7. Enter the number to access the external voice mail system.Set Telco features for the VM DN1. Press – until you reach the top level, then press‘ until the prompt displays Terminals&Sets.2. Press ≠. The prompt displays: Show set:3. Enter the DN for the voice mail system.4. Press ≠. The prompt displays Line access.5. Press ‘ until the prompt displays Telcofeatures.6. Press ≠. The prompt displays Feature Assign.7. Press ≠. The prompt displays Show line.8. Enter the line number that connects to the system for thecentral voice mail system.9. Press ≠. The prompt displays Caller ID Set.
