60 / Working with ISDNModular ICS 6.0 Installer Guide P0992638 03Programming ISDN BRI resourcesSome steps will not be necessary depending on the service youare providing.More detailed information is included under the individualheadings and settings in the Programming and Maintenancesections.For complete card and cartridge installation instructions andsafety precautions, see Installation on page 209.1. Collect the information supplied by your service providerto support your ISDN package. This includes networkservice profile identifiers (SPIDs) and Network DNs. Ifyou are supporting a point-of-sale terminal adapter, youalso need one or more terminal endpoint identifiers (TEIs).2. Make sure a Combination Fiber 6-port Services Cartridge,or a Services Cartridge has been installed in the ICS.3. Install the BRI card in the ICS, Trunk Module. Refer toInstalling the cartridges on page 213 for information aboutBRI card placement. If you are not using a BRI card,determine which type of card you will preprogram the ICSto use in each slot.4. Disable each card in Maintenance under ModuleStatus.5. Under Hardware, select a card type: BRI-ST, BRI-U2,BRI-U4.6. Under Hardware, select the type for each loop:• for a BRI card, select T or S if the card type is BRI-ST• for a BRI-U2 or BRI-U4 card, select LT or NT
