Installing the cartridges / 213P0992638 03 Modular ICS 6.0 Installer GuideInstalling the cartridgesThe following table shows you which cartridges can beinstalled in which ICS and TM slots.Note: Use Slot 1 only when installing cartridges for 12-port, fullyexpanded systems. In this case, both slots 1 and 2 are installed with6-port Expansion or a Combination Fiber 6-port Services Cartridge.If you use both slot 1 and 2, the software must be MICS-XC.Cartridge type ICS Slot TM SlotModular ICS NVRAM cartridge Feature CartridgeSlotModular ICS ROM software cartridges:USA-MICS-XC 6.0CDA-MICS-XC 6.0NA-MICS 6.0NVRAM CartridgeSlotServices Cartridge 1Fiber Expansion Cartridge (2-port) 2Fiber Expansion Cartridge (6-port) 1 or 2(see note below)Combination Fiber 6-port Services Cartridge 1 or 2(see note below)Digital Trunk Interface (DTI) card configured for TI card or PRI 3 or 4MICS 6.0: Global Analog LS/DS trunk cartridge replaces:Loop Start Disconnect Supervision (LS/DS) Trunk Cartridge3 or 4 1, 2 or 3MICS 6.0: Global Analog CLI trunk cartridge replaces:Caller Identification (CI) Trunk Cartridge3 or 4 1, 2 or 3E&M Trunk Cartridge 1, 2 or 3DID Trunk Cartridge 1, 2 or 3Copper Expansion (2-port) 1Copper Expansion (6-port) 1BRI-ST card 3 or 4 1, 2 or 3BRI-U2 card 3 or 4 1, 2 or 3BRI-U4 card 3 or 4 1, 2 or 3