Chapter 5 Managing the Passport 8672ATME Module with the CLI 113Using the Passport 8672ATME ModuleFor example, to enable F5-OAM Loopback for VPI=0 & VCI=33 in port 6 of anATM card in slot 3, and configure it with trap enabled, a retry-frequency of 2seconds and up-count of 5 times, you would enter the following command:Passport-8610:5# config atm 3/6 pvc f5 0.33 enable trap enableretry 2 up 5To disable the F5-OAM Loopback for VPI=0 & VCI=33 in port 6 of an ATM cardin slot 3:Passport-8610:5# config atm 3/6 pvc f5 0.33 disableshow ports info atm pvc [slot/port]The show ports info atm pvc [slot/port] command displays theF5-OAM Loopback configuration among other PVC configurations.Figure 47 displays sample output for the show ports info atm pvc[slot/port] command.down 5 responses 1..255 Sets the number of consecutive F5-OAM Loopbackreplies that must fail to change the Loopback Stateto “down.” This configuration is also referred as“down-count”.trap disabled Enable/Disable Enables/disables the transmission of an SNMP Trapwhen the F5-OAM Loopback changes from theDOWN VERIFY to DOWN state or from the UPVERIFY to UP state.Table 39 F5-OAM Loopback parameters (continued)Configuration Default Values Description
