76 Chapter 5 Managing the Passport 8672ATME Module with the CLI209195-BConfiguration commandsThis section describes the CLI configuration commands available with thePassport 8672ATME Module. There are three types of configuration commands:• “Module commands,” next• “1483 ELAN statistics” on page 77• “Port commands” on page 79Module commandsThe module commands allow you to:• Reset the module• View ELAN statistics• Display the image filename for the Passport 8672ATME Module.The syntax is:config atmcard <atmslot number>The required variable <atmslot number> is the slot number of the module inthe Passport 8600 chassis. Table 15 describes the parameters and variables for theconfig atmcard command.Note: If you replace one card with another type of card, NortelNetworks recommends that you go to the root level of the CLI directorybefore using any CLI commands.
