118 Chapter 6 Configuring the Passport 8672ATME Module209195-BBefore you can pass traffic using the Passport 8672ATME Module with itsinstalled MDA, you must change the clock setting. You can do this in one of twoways:• “Changing the clock setting using Device Manager,” next• “Changing the clock setting using the CLI” on page 119Changing the clock setting using Device ManagerThis section provides instructions on changing the clock setting.To change the clock setting using Device Manager:1 Highlight the port.2 Choose Edit > Port.The Port dialog box opens with the Interface tab displayed (Figure 12 onpage 52).3 Click the ATM tab.The ATM tab opens. (Figure 49).Note: The Passport 8672ATME Module supports only Ethernet ELANs.Note: If you are connecting one Passport 8672ATME Module directlyto another Passport 8672ATME Module without going through theSONET cloud, the clock mode at both ends of the circuit may befree-running, but only one end of this circuit may be configured asloop-timed.