136 Chapter 6 Configuring the Passport 8672ATME Module209195-B5 Click Enable.6 Click Apply.The OSPF tab closes, and the IP Address tab is redisplayed.7 Click Close.Configuring a null-encapsulation PVCSee “Configuring two ATM 1483 PVCs on the same ATM port” on page 128.Associating the PVC with the VLANSee “Associating the PVC with the VLAN” on page 126.Follow the instructions there except, in the ConnectType field, select IP instead ofbridged.Configuring an IP routing 1483 PVC using the CLITo configure the Passport 8672ATME Module for an ATM 1483 IP routed PVC,using the CLI:1 To create two VLANs by port, enter:config vlan 2 create byport 1config vlan 3 create byport 1AreaId A 32-bit integer uniquely identifying the area to which theinterface connects. Area ID 0.0.0.0 is used for the OSPFbackbone.AdvertiseWhenDown Value used indicates whether or not a VLAN state changeshould be notified to layer 3, provided that the VLAN isconfigured as a routable interface. Also used for single routableports. In that case, the criteria for state is PortOperStatus.Table 48 OSPF tab fields (continued)Field Description
