|
Chapter 5 Managing the Passport 8672ATME Module with the CLI 81Using the Passport 8672ATME Moduleconfig atm pvc commandTable 18 describes the parameters and variables for the config atm pvccommand.state Sets the state of the port to enabled or disabled.info Shows the last saved port settings and the next-level CLI commands.Note that this does not show the current settings, but the last savedsettings.Table 18 config atm pvc command parameters and variablesParameters and variables Descriptioncreate < vpi.vci> [name ][enc ] [serv ] [pcr] [scr ] [mbs]Creates a PVC. The required parameters are:• vpi is the circuit VPI. Enter a numeric value, within the range.• vci is the circuit VCI. Enter a numeric value, within the range.For OC-3c, 11 bits split between Vpi and Vci. Vpi bits cannotexceed 6 bits for OC-3c.For OC-12c, 13 bits split between Vpi (default is 4) and Vci (defaultis 9). Vpi bits cannot exceed 8 bits for OC-12c.Note: For , 0.0 is not supported.The optional parameters are:• name is the display string. Enter up to 256 alphanumeric charactersto name PVC.• enc is the 1483 encapsulation method, either null or llc-snap.• serv is the bit rate, either ubr or vbr.• pcr, with VBR only, is the peak cell rate. The valid ranges are:OC-3—86..182783OC-12—86..733490• scr, with VBR only, is the sustained cell rate. The valid ranges are:OC-3—86..182783OC-12—86..733490• mbs, with VBR only, is the maximum burst size. Enter an integerfrom 2 to 255.Note that no VLANs or ELANs are bound to this PVC until you addVLAN membership using the config atm pvc 1483 commands.Table 17 config atm command parameters and variables (continued)Parameters and variables Description PreviousNext |