Chapter 5 Managing the Passport 8672ATME Module with the CLI 115Using the Passport 8672ATME ModuleTable 40 defines the status and statistics in the show ports info atm f5-oam[slot/port] command.clear atm f5-oam [slot/port]This command clears the F5-OAM statistics for all the F5-OAM loopbacks thatare currently enabled under the ATM port and slot.To clear all the F5-OAM statistics for a particular ATM port and slot, enter thiscommand:Passport-8610:5# clear atm f5-oam 2/3Table 40 Status and statistic definitionF5 VC Status DefinitionNOT MANAGED The VC is not being managed by OAM. (The VC is nottransmitting F5-OAM Loopback Requests as F5-OAM Loopbackis disabled.)DOWN VERIFY An OAM loopback failed. End-to-end F5-OAM loopback cells aresent at the specified retry frequency to verify that the VC isdown. After down-count unsuccessful retries, the VC goes to thedown state (see LbDownCount in Table 13 on page 71).DOWN The VC has not received responses to end-to-end F5-OAMloopback cells.UP VERIFY An OAM loopback was successful. End-to-end F5-OAMloopback cells are sent at the specified retry frequency to verifythe VC is really up. After up-count successive and successfulloopback retries, the VC goes to the Up state (see LbUpCount inTable 13 on page 71).UP End-to-end loopbacks are successful.Loopback Req Sent Number of F5-OAM Loopback requests transmitted for aparticular PVC.Loopback Reply Rcv Number of F5-OAM Loopback replies received for a particularPVC.Loopback Reply Sent Number of F5-OAM Loopback replies transmitted in response toa F5-OAM Loopback Request Received for a particular PVC.Although this functionality occurs while the F5-OAM Loopback isdisabled, this statistic only starts when the F5-OAM Loopback isenabled.