Chapter 6 Configuring the Passport 8672ATME Module 137Using the Passport 8672ATME Module2 To add an ATM port (in this example, 1/1) and several Ethernet ports (in thisexample, 3/40 to 3/48) to the VLAN, enter:config vlan 2 port add 1/1config vlan 3 port add 3/40-3/483 To configure IP addresses on both VLANs (use two different subnets), enter:config vlan 2 ip <ip address>/<subnet mask>config vlan 3 ip <ip address>/<subnet mask>4 To enable routing on both VLANs, enter:config vlan 2 ip rip enableconfig vlan 3 ip rip enableIf necessary, use the following CLI commands to change RIP parameters:config vlan 2 ip rip <sub-command>config ip rip <sub-command>5 To configure an ATM 1483 PVC with LLC/SNAP-encapsulation and UBR,enter:config atm 1/1 pvc create 0.100 enc 1483-llc servubr6 To associate the 1483 IP routed PVC with a VLAN, enter:config atm 1/1 pvc 1483 ip create 2 0.100 emoteside IP address>The remote IP address should be in the same subnet with the ATM port IPaddress.Configuring an IPX routing 1483 PVC using Device ManagerIn the configuration shown in Figure 60, the Passport 8672ATME Module has anATM 1483 PVC as the sole member of a VLAN configured for IPX routing.
