Oki MC780 User Manual

Also see for ES7460 MFP: User manual User manual User manual User manual User manual

Contents

Oki MC780 User Manual Manual pdf 33 page image

HOW TO MAKE COPIES- 33 -123456Scanning the next original duringcopyingEven if copying is in progress or “READY (WARMING UP)” isdisplayed on the touch panel, you can scan the next original(auto job start).1 Place the original(s).2 Set the number of copy sets and the copymodes as required.Note• The new job starts in the copy modes that youpreviously selected unless you select other modes.3 Press the [START] button on the controlpanel.Memo• A maximum of 1000 sheets can be scanned per 1 copyjob or up until the embedded memory becomes full.Confirming auto jobsYou can confirm which jobs are in waiting on the touch panel orcancel them as required. For details, see the following Guide: Advanced GuideCanceling jobs being scannedPress the [STOP] button on the control panel to stop a jobwhile originals are being scanned.When you press [JOB CANCEL] on the touch panel or the[RESET] button on the control panel while the scanning isbeing paused, the scanning will end. (In this case, the datawhich were scanned before the job was paused will be copied.)To restart the scanning, press the [START] button.Interrupting copying and making othercopiesYou can interrupt the copy job in progress to make other copies(interrupt copying). When restarting the interrupted job, you donot have to reselect copy modes that have been set becausethey are memorized in this equipment.Note• The following functions cannot be used together withinterrupt copying:Cover sheet copying, Sheet insertion copying, Job build,Store to e-Filing, Copy & File• During interrupt copying, the mode cannot be changed to anon-copying one, such as e-Filing, scanning, printing or fax.To change the mode, first press the [INTERRUPT] button toclear the interrupt copying.1 Press the [INTERRUPT] button on thecontrol panel.“Job interrupted job 1 saved” appears, and“COPY(Interrupt)” is displayed on the function display.Memo• If the original is being scanned, the message aboveappears after the scanning has finished.2 Replace the original with a new one.3 Select other copy modes as required andthen press the [START] button on thecontrol panel.4 Press the [INTERRUPT] button again afterthe interrupt copying has finished.“Ready to resume job 1” appears and the interrupted jobrestarts.Proof copyWhen you make a large amount of copies, you can check ifthey will be made exactly as you desire by copying only onepage before copying them all (proof copy). Then you canchange the modes or settings (e.g. the number of copy sets,receiving tray, page number, time stamp, sort/stapling) afterchecking the proof copy.