BASIC COPY MODES- 44 -123456Even if you do not do so, the changes will be cleared if theequipment is left idle for 45 sec. (default setting).Restrictions on function combinationsSeveral copy functions can be used together. However somefunctions may not be used with other ones. For details, see thefollowing Guide: Advanced GuidePaper SelectionAutomatic Paper Selection (APS)This equipment detects the size of an original and selectspaper of the same size automatically. This function is calledAutomatic Paper Selection (APS).Memo• For the original sizes detectable, see the following page: P.28 "Acceptable originals"• Some original sizes may not be detected with this function.In this case, select the desired size manually. P.44 "Selecting desired paper manually"1 Place paper in the tray(s).2 Place the original(s).3 Press [APS] on the touch panel.The paper selection mode is now set at Automatic PaperSelection.Memo• The paper selection mode is set at Automatic PaperSelection by default.4 Select other copy modes as required, andthen press the [START] button on thecontrol panel.Selecting desired paper manuallyYou need to select paper by yourself when copying by placingthe original on the original glass, or when copying the followingoriginals whose sizes cannot be detected correctly:• Highly transparent originals (e.g. OHP film, tracing paper)• Totally dark originals or originals with dark borders• Non-standard size originals (e.g. newspapers, magazines)Memo• When paper of the size you want to use is not in any tray,place it in a tray or on the bypass multi-purpose tray (MPT). P.35 "Bypass Copying"1 Place paper in the tray(s).When using bypass copying, be sure to set the papersize.2 Place the original(s).3 Press the tray button corresponding to thedesired paper size.4 Select other copy modes as required, andthen press the [START] button on thecontrol panel.