HOW TO MAKE COPIES- 40 -1234566 Press [ZOOM] on the touch panel.7 Press [SIZE SETTING] on the touch panel.8 Press the button of the same size as theenvelope you placed on the multi-purposetray.The size of the selected envelope will be registered as an“OTHER” size.9 Press [OTHER] under “COPY”.The paper size is now set to the size of the envelopeplaced on the multi-purpose tray. The paper type isautomatically set to [ENVELOPE].10 Select other copy modes as required, andthen press the [START] button on thecontrol panel.Copying starts.When the Inner Finisher is installed, the envelope exits tothe receiving tray of the finisher.Note• Every 10 copies, take the envelopes out from the facedown/up stacker.Bypass copying on non-standard sizepaperYou can use non-standard size paper within the sizes shownon the right.1 Place the original on the original glass.2 Place the paper with its copy side face upon the multi-purpose tray.Note• The height of the paper must not exceed the indicatoron the side guides.• When you use more than one sheet of paper, fan thesheets well before placing them on the multi-purposetray. Be careful not to cut your fingers when fanning.• Do not push paper into the entrance of the bypassfeeder. This could cause a paper misfeed.64 - 216 mm127 - 356 mm
