BASIC COPY MODES- 51 -1234566 Select the desired copy paper size, andthen press [OK].Note• If you want to select a paper size other than thefollowing, you need to register the size as “OTHER”size. In this case, register it in a landscape direction.Once you register this size, it will be specified everytime you press [OTHER] on the touch panel.North America: LG, LT,STOther than North America: A4, B5For how to register it, see the following page: P.49 "Registering paper sizes to “OTHER” size"7 Select other copy modes as required, andthen press the [START] button on thecontrol panel.If “NON-SORT NON-STAPLE” is selected as a sortingmode, scanning of the original starts. If another sortingmode is selected, follow the procedure below.8 Place the next original, and then press[NEXT COPY] on the touch panel or the[START] button on the control panel.Scanning of the next original starts. If you have more thanone original, repeat this step until the scanning of all theoriginals is finished.9 When the scanning of all the originals isfinished, press [JOB FINISH] on the touchpanel.Copying starts. Setting photo originals in other sizes1 Press [CUSTOM] on the touch panel.2 Key in the size of the original.1) Press [X] on the touch panel and key in its width within10 to 434 mm (0.39" to 17.09").2) Press [Y] on the touch panel and key in its lengthwithin 10 to 300 mm (0.39" to 11.81").3) Press [OK] on the touch panel.Selecting Finishing ModeFinishing modes and optional finishingdevicesSee the table below for each finishing mode.The available finishing modes differ depending on the type ofoptional finishing devices (Inner Finisher) installed. Finishingdevices available for this equipment are as follows:Finishing mode DescriptionNon-sort Non-staple Copies exit without being sorted orstapled.Sort ( P.52) Copies exit in the same page orderas the originals one set after another.Group ( P.52) Copies grouped by page exit.Staple sort ( P.53) Copies exit with their corner stapled.Magazine sort (P.54)Copies exit in a book-type pageorder.