III - 16Section 3 - Chapter 2 - OkiNet for NetWareOKI OkiLAN 6120e User’s GuideTrap Destination• NetWare Protocol - Enter the network number andhardware address, respectively, to which traps willbe sent. To broadcast traps to all addresses on allnetworks, enter FFFFFFFF (8 characters) in the firstfield and FFFFFFFFFFFF (12 characters) in thesecond field. To broadcast traps to all addresses on aspecific network, enter the network number in thefirst field and then FFFFFFFFFFFF (12 characters)in the second field.• TCP/IP Protocol - Enter the IP address to whichtraps will be sent. The IP address must follow theformat XXX.XXX.XXX.XXX, where each XXX isa number from 0 to 255. To broadcast traps to allhosts on the local subnet, enter 255.255.255.255.Ports to TrapSelect the output ports on which you wish traps to beactive.Printer TrapsSelect the printer traps to be activated. The followingprinter conditions may cause a printer trap to occur ifthe OKI printer model supports the features:• On-line• Off-line• No Printer Attached• Paper Out• Toner Low• Paper Jam• Door Open• Printer ErrorNote: Toner Low, Paper Jam and Door Open requirethe printer to be set in PCL or Auto mode.Saving the ConfigurationOnce all settings have been defined, select OK. Thesettings will be saved and you will be returned to themain OkiNet for NetWare screen.
