- 162 -Using a Web Browser to Configure the Network Setup10 Click [OK].11 Select the printer name, and then click[Next].12 Click [Next].13 Click [Finish].14 A test page is printed after installationis complete.Encrypting Communication(IPsec)You can configure the settings in this sectionto encrypt and prevent tampering withcommunication between the computer (client)and printer at the network layer level.Memoz The IKE protocol supported by this printer is "IKEv1".The communication mode supported by this printer is"Transport Mode". It does not support "Tunnel Mode".Printer response may slow down while IPsec is enabled,depending on network communication conditions.Notez IPsec does not operate with the mail send function orSNMP Trap function. Setup FlowConfigure printer settings before configuringcomputer settings. To configure the printer setupThe procedure below shows how to use the webto enable IPsec.1 Log in as an administrator.Referencez See "Logging in as an Administrator" (P.154).2 Click in the following sequence: [AdminSetup] > [Network Setup] > [Security].3 Click the [IPsec] tab.
