- 56 -Table of Setting Items in the Control Panel Menu ScreenItem Value DescriptionSensorCalibrationSet1 :Set2 :Set3 :Set4 :Set5 :Set6 :Set7 :Set8 :Set9 :Set10 :Execute Calibration Execute Executes calibration of the gap sensor orblack mark sensor.AdjustSliceLevelReflectiveSensor inUnwinder0～1023Fine tunes the sensitivity of the reflectivesensor in the unwinder that was measuredduring Sensor Calibration.The default value fluctuates according tothe results of the calibration.Appears when the black mark sensor isused.ReflectiveSensor inPrinter0～1023Fine tunes the sensitivity of the reflectivesensor in the device that was measuredduring Sensor Calibration.The default value fluctuates according tothe results of the calibration.Appears when the black mark sensor isused.TransmissionSensor inUnwinder0～1023Fine tunes the sensitivity of thetransmission sensor in the unwinder thatwas measured during Sensor Calibration.The default value fluctuates according tothe results of the calibration.Appears when the gap sensor is used.TransmissionSensor inPrinter0～1023Fine tunes the sensitivity of thetransmission sensor in the device thatwas measured during Sensor Calibration.The default value fluctuates according tothe results of the calibration.Appears when the gap sensor is used.Change Name Execute You can change the name of the specifiedsetting numbers.You can use up to eight characters ofsingle-byte upper case English andnumbers.Reset Setting Execute Initializes the content of the specifiedsetting numbers.Check Media Pitch Execute Measures the intervals on the paper.Appears when the [Media Form] issomething other than [Continuous Paper]or [Continuous Label].
