- 54 -Table of Setting Items in the Control Panel Menu ScreenItem Value DescriptionY Dimension 12.7 millimeter(0.50 inch)～101.6 millimeter(4.00 inch)～148.0 millimeter(5.83 inch)152.4 millimeter(6.00 inch)～1320.8 millimeter(52.00 inch)Sets the length of the custom paper sizesfor the unwinder.Sets the same direction as for thedimension in the paper feed direction.If the setting is 101.6 mm (4.00 inch) orlower, then the set page length is handledas a whole-number multiple of the actuallength of the page such that it exceeds101.6 mm (4.00 inch).The initial values vary depending on youroperating environment.Appears when the Media Form is[Continuous Paper], [Die-cut Label(Gap)], [Die-cut Label (Black Mark)] or[Continuous Label].Black Mark Interval 15.9 millimeter(0.63 inch)～101.6 millimeter(4.00 inch)～151.2 millimeter(5.95 inch)155.6 millimeter(6.13 inch)～1324.0 millimeter(52.13 inch)Sets the interval of the marks on custompaper for the unwinder.Sets the same direction as for thedimension in the paper feed direction.If the setting is 104.8 mm (4.13 inch) orlower, then the set page length is handledas a whole-number multiple of the actuallength of the page such that it exceeds101.6 mm (4.00 inch).The initial values vary depending on youroperating environment.Appears when the Media Form is[Continuous Paper (Black Mark)] or[Continuous Label (Black Mark)].Gap Length 3.0 millimeter(0.12 inch)～10.0 millimeter(0.39 inch)Sets the interval for labels.Sets the same direction as for thedimension in the paper feed direction.Appears when the Media Formis [Die-cut Label (Gap)] or[Die-cut Label (Black Mark)].Adjust Cut Position -0.5 millimeter(-0.02 inch)～0.0 millimeter(0.00 inch)～+0.5 millimeter(+0.02 inch)Specifies the compensation value forthe distance from the print completionposition to the cut position (beginning ofnext label). (Specifies margin on followingedge)If you specify a negative value, cutting isdone at a short position.z Shaded areas are factory-set values.
