- 53 -Table of Setting Items in the Control Panel Menu Screen[Menus] Unwinder Config z Shaded areas are factory-set values.Item Value DescriptionMedia Form Continuous PaperContinuous Paper(Black Mark)Die-cut Label (Gap)Die-cut Label (BlackMark)Continuous LabelContinuous Label(Black Mark)Specifies the shape of the roll paper.Liner Width Config Liner WidthModeAutoCustomSpecifies the mode for setting the widthof the label’s liner.Auto:The width of the liner is set given thatthe label is in the center of the liner.Custom:The width of the liner is input and theleft gap is calculated given that the leftand right gaps are different.Liner Width 29.4 millimeter(1.16 inch)～105.6 millimeter(4.16 inch)109.0 millimeter(4.29 inch)～130.0 millimeter(5.12 inch)Inputs the width of the liner.Appears when the [Liner Width Mode] is[Custom].The initial values vary depending on youroperating environment.Right Gap 2.0 millimeter(0.08 inch)～25.4 millimeter(1.00 inch)Specifies the distance from the right edgeof the label to the right edge of the liner.Paper Size A64x6 inchCustomSets the size of the paper for theunwinder.The initial values vary depending on youroperating environment.X Dimension 25.4 millimeter(1.00 inch)～101.6 millimeter(4.00 inch)105.0 millimeter(4.13 inch)～126.0 millimeter(4.96 inch)*1Sets the width of the custom paper sizesfor the unwinder.Sets the dimension perpendicular to thepaper feed direction.The initial values vary depending on youroperating environment.*1: 130.0 mm (5.12 inch) if the [Media Form] is [Continuous Paper] or [Continuous Paper (Black Mark)]
